Assembly Instructions
LED modules are polarity conscious.
Reverse polarity will not damage this product but will
inhibit its function.
Hella recommends wire connections be soldered,
and heat shrink tubing applied to seal the joint.
Note:
Lamp must be protected by a fuse rated at 3 amperes
maximum.
Wiring Colour Coding
Colour
Connect to
Black
Negative (-ve)
Red
Signal (+ve)
Correct Positioning
NaviLED
®
360 All Round / Anchor
Lamps must be installed as follows:
When the lamp operates, the light should not
be obstructed or concealed by masts,
topmasts or structures, i.e. installed on the
highest point of a vessel so the light arc is
unbroken.
All Round lamps must be positioned as close
as practicable to the fore and aft centre line
of a vessel. (see Fig.1)
The All Round white lamp on a power driven
vessel less than 12m in length shall be
installed at least one meter higher than the
sidelights.
The lamp must be installed so that the
horizontal surface of the base is parallel to
the vessel's water line. (see Fig.2)
Fig. 1
On the fore and aft centre line.
Fore
Centre Line
Aft
Fig. 2
Installed so base is parallel to vessel's
water line.
www.hellamarine.com
Step 3
3.1 Push Lamp Module into
the Mounting Cup
3.2 Twist clockwise to lock
3.3 Connect power
Step 2
2.1 Feed cable through centre hole
of the Mounting Cup
2.2 Fix Cable Clamp
Step 1
Fix Mounting Cup with direction arrow
pointing straight ahead.
Mounting Cup
Cable Clamp
Lamp Module
Fore
Aft
Note:
Do not open Lamp Module
No servicable parts inside.
Rotate clockwise to lock
Vessel's water Line
Dimensions
a = 56mm / 2.20”
b = 60mm / 2.36”
c = 33mm / 1.30”
a
b
b
c
SIDE VIEW
