Hella Gutmann Radar Kit III, Operating Instructions Manual

Page: 32 / 312

EN
Working with the Radar Kit III Radar Kit III
Adjusting the Front Radar
3. Align the shaft with the cross connector (15) to the wheel center
1
.
4. Align the scales of the wheel alignment module in right angle.
NOTE
• Ensure that the level bubbles of both wheel alignment modules are centred.
• The distance between the base support and the center of the wheel can be measured with a
tape measure (not included in the delivery contents) only if the wheel alignment module is
attached horizontally and centred to the wheel center.
5. Align the laser module to the even ground by turning it.
CAUTION
Laser radiation
Damage to/destruction of the retina
Never look directly into the laser beam.
6. Switch on the laser module.
The laser point is indicated on the even ground surface.
7. Perform steps 5 and 6 for the second laser module.
Now both wheel alignment modules are correctly attached to the front wheels.
5.2.2 Positioning the Base Support at the Right Distance
and Parallel in Front of the Vehicle
Proceed as follows to place the base support of the Rear Cam Kit I Basic at the right distance and parallel in front of
the vehicle:
1. Connect the diagnostic device to the vehicle (see mega macs user manual).
2. Select >Diagnostics< in the main menu.
3. Select the system to be calibrated under >Basic settings< .
4. Position the base support in front of the vehicle.
32