Hella Gutmann Radar Kit III, Operating Instructions Manual

Page: 31 / 312

EN
Radar Kit III Working with the Radar Kit III
Preconditions for the Use
5 Working with the Radar Kit III
5.1 Preconditions for the Use
Ensure the following to be able to use the Radar Kit III:
• The vehicle system to be adjusted is working properly.
• There are no trouble codes stored in the ECU.
• Vehicle-specific preparations have been done.
• Rear axle track OK.
• The horizontal alignment of the vehicle on even floor is ensured.
• The Rear Cam Kit I Basic (if necessary with positioning aid) is present (not included in the delivery contents).
• Two wheel alignment modules are present (not included in the delivery contents).
• The radar reflector CSC 4-04 or CSC 4-05 respectively is positioned correctly in front of/behind the vehicle.
• The minimum dimensions indicated in the diagnostic device regarding the correct positioning have been obeyed.
• The note given in the diagnostic device regarding the areas in which reflecting objects shall not be present has
been obeyed.
5.2 Adjusting the Front Radar
5.2.1 Attaching the Wheel Alignment Modules to the Front Wheels
Proceed as follows to attach the wheel alignment module to the front wheel:
1. Attach one wheel alignment module on the left and right front wheel respectively.
WARNING
Sharp object
Risk of injury/piercing
Always use the handle to attach the wheel alignment module to the rim flange or tire.
CAUTION
Scratching of surfaces
Damage to wheel rims
Always attach the protective cylinder set to the rim flange or tire.
2. Loosen the set screw of the shaft with the cross connector.
Now you can adjust the height of the shaft with the cross connector.
31