3.3 Storage
•
The device must be stored in its original packaging in a dry and weather-proof
room.
•
Avoid exposure to extreme heat and cold.
•
Avoid over-long storage periods (we recommend a maximum of one year).
3.4 Disposal / recycling
Disposal must be carried out professionally and environmentally friendly in accordance
with the legal stipulations.
4 Mounting
4.1 General notes
Attention!
The following points must be complied with during the mechanical installation to avoid
causing a defect in the device due to assembly errors or environmental in
fl
uences:
•
Before installation remove the device from the packing and check for any possible
shipping damage!
•
Assemble the device on a clean and stable base. Do not distort during assembly!
Use the appropriate mounting devices for proper installation of the unit!
•
Do not mount equipment on vibrating base!
•
When mounted onto lightweight walls, there must be no impermissibly high
vibrations or shock loads. Any banging shut of doors that are integrated into these
lightweight walls, can result in extremely high shock loads. Therefore, we advise
you to decouple the devices from the wall.
•
Do not allow drilling chips, screws and other foreign bodies to reach the device
interior!
•
The device should be installed in a location where it will not be disturbed, but at
the same time can be easily accessed!
•
Any cable ducts openings not used must be sealed!
•
Care must be taken to avoid direct radiation from the sun!
•
The pressure measuring depends on position, therefore the mounting must be
made vertical and as possible on a vibration-free place (cable inlet and pressure
connections down).
•
The pressure line
´
s connection should be with plastic-hose (in building), inside
diameter 4 / 5 mm.
4.2 Temperature in
fl
uences during commissioning
Avoid condensation in the controller and functional faults attributable to condensation by
storing the controller at room temperature!
Installation and Operating Speci
fi
cation
EDR
Mounting
L-BAL-E192-GB 1320
Part.-No.
6/17