...ADJUSTING AND TUNING YOUR DOMINUS 10TR CONTINUED
SAFETY TIPS
GENERAL CARE AND MAINTENANCE...
10
Although great for fi rst time users, Helion RC products are indeed advanced radio controlled vehicles with sensitive electronics and
moving parts capable of causing injury if used improperly. Always use caution and common sense as failure to operate your Helion
RC product in a safe and responsible manner can result in damage to the product or other properties. Therefore this product is not
intended for use or maintenance by children without direct adult supervision. Helion RC and your hobby dealer shall not be liable
for any loss or damages, whether direct, indirect, special, incidental, or consequential, arising from the use, misuse, or abuse of this
product or any product required to operate or maintain it.
• Do not operate your vehicle in rain, electrical, or thunder storms.
• The vehicle should never be turned ON without the transmitter being turned ON.
• Never operate your vehicle when with low transmitter batteries.
› Indicated by fl ashing LED on the transmitter.
• Always check for proper radio system operation (steering and throttle) prior to letting go of the vehicle. If the vehicle does not
respond properly to transmitter input, turn the vehicle OFF and inspect all connections and operating environment. Also see the
Troubleshooting guide in this manual.
• Optimal enjoyment and safety will occur in a dry (no puddles), open environment away from traffi c, and cars (never run into the
street for any reason).
• Always turn off both transmitter and ESC and disconnect the battery from the ESC after use.
• Exercise extreme caution when touching the motor and battery connectors immediately after running your vehicle, they may be
HOT and cause a burn.
• Always allow the motor in your vehicle to cool before using again.
NOTE: Only use genuine replacement or aftermarket parts available from your local hobby dealer to ensure proper opera-
tion of your Helion RC product.
Lower Shock Position:
There are two shock installation locations for the lower mounting location of the shocks in the suspen-
sion arm. The default location is outside. Moving the shocks to the inside location will result in a slightly more responsive feel on the
front or rear of the vehicle but become a little less stable. This change will also increase the vehicle’s articulation and you will notice
more body roll. Always check and adjust, if necessary, the ride height of your vehicle after moving the shock mounting locations.
Battery mounting:
Your vehicle comes equipped with and default mount setting for a 7-Cell NiMH hump battery. It is also pos-
sible to fi t a 6-Cell size NiMH (or standard hard case 7.4V LiPo). The battery mounting posts have multiple holes to adjust for battery
packs of different heights. Adjust the battery strap height to fi t the battery you will use.
Body Mount Height:
The body mounts are capable of vertical adjustment with many height options available. The default set-
ting allows for the lowest body position while maintaining component clearance. Adjust the body mounts to achieve a desired look,
we recommend the lowest possible mounting for best performance.
General Care:
• Always use clean, dry cloth or soft bristle brush to clean your equipment.
• Never use chemical cleansers to avoid damage to the sensitive electronics and plastics.
Maintenance:
We want you to enjoy your product to its fullest potential. For this to happen it is important to keep your product clean and properly
maintained. Lack of cleaning and maintenance can cause component failure. For best and continued performance from your product
it is recommended to briefl y inspect your product for damage every few runs. Typically, a good time to do this is when changing the
battery or while it is charging. If a problem is discovered, stop use immediately and perform repairs or seek assistance. Continued
use of failed components can cause more unnecessary damage to your product. Always remember to use genuine replacement
parts from your local hobby dealer. Below is a list of items for inspection. Inspection should not be limited to this list; if you notice
any problem, listed or not, it is recommended to give it proper attention.
1. Electronics: Although the ESC and servo included in your vehicle are waterproof the receiver is not, however it is contained in a
water resistant box. It is recommended that you avoid submersion of the vehicle however light running in puddles and light rain
should not be damaging. If you plan to run for extended periods of time in light or heavy rain It is recommended to secure the
receiver in an additional waterproof membrane. Since the Helion HRS-3.1 receiver is a micro size receiver, fi tting it into a balloon
is fairly easy. Simply insert the receiver with connected wiring into a balloon and secure the balloon around the wires with an
additional rubber band as close to the receiver as possible, allowing the most exposure of the antenna as possible.
2. Antenna: To achieve full operating range with your radio system, it is critical that the receiver antenna be installed properly and
undamaged.
a. Inspect any exposed antenna for cuts or abrasions.
