Heli-Professional REVOLUTION 500E, Manual

Page: 4 / 41

www.heli-professional.com 4
·
The battery must neither be overcharged nor exhausted. The battery is totally damaged and cannot be used an-
ymore in case of an exhaustive discharge. Therefore do not exceed following flight times:
Flight Style 3D Mode Max. Flight Time*
Hover Off 6.5 Minutes
Basic Flight Off 5.5 Minutes
Aerobatics On 4 Minutes
* Please note: the max. flight time will be shorter in cold condition or with old batteries.
·
Heli Professional will not accept responsibility for any damage or secondary failures caused by inappropriate use
and rejects any liability, as we are not in a position to supervise proper operation, handling, and maintenance.
Checklist Maiden Flight
Attention: This checklist is supposed to give you a short overview of the preparations for the maiden flight and does
not replace the contents of this manual.
·
Unbox and check all parts for damage.
·
Check if all screws are fully tighten
·
Check if all connectors are plugged in securely
·
The main blade screws must be tightened until the blades can only be moved with a lot of force
·
Charge the battery with the included charger according to the instructions. Notice the safety instructions and pay
attention to the correct polarity of the charger, the balancer and the ESC of the model.
·
Insert AA batteries into the Transmitter. Do not change the settings of the transmitter in any way!
·
Position and tighten the fully charged battery according to the picture on the battery plate with the included
hook and loop fasteners and secure it with O-rings in the helicopter model.
·
Secure the balancer plug under the hook and loop fastener according to the picture.
·
Test all functions of the model. The FBL-3X system and the transmitter are already programmed. No further set-
tings are required.
·
The initial startup should be done on an appropriate airfield. Local clubs generally offer the best possibilities for
safe and fun helicopter flying.
Checklist Regular Flights
Attention: This checklist is supposed to give you a short overview of regular flights and does not replace the contents
of this manual.
·
Check all connections and screws before every flight
·
Secure the battery with O-rings in the battery rails and connect the ESC with the battery.