17
Press the video button (Tx-R, Flip the switch) again to start taking video.
Press the video button (Tx-R, Flip the switch) once again to stop taking video.
NOTE:
The LED of the camera will flash letting you know you’re actively
taking video. It’s also important to know that if you unplug the main power
battery while taking video you will lose that capture.
Taking Photos
Press the photo button to “enter photo mode.” If you are using the Tx-R
model and have it on a two position switch, you will need to cycle the switch
to enter photo mode.
Press the photo button again to take a picture. Note: The camera will take
one photo per button press.
NOTE:
The LED will flash during the picture capture. When the LED completes
flashing the camera is ready to take another picture.
Downloading Video and Pictures From the Camera
Install the Micro SD card into the reader. Plug the reader into the USB port
of your computer.
The USB connection will be auto recognized and the files ready to be transferred.
At this point you can copy or transfer your files to your folder structure.
®
TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM:
V-Cam does not react to any stick movements.
Solution:
If the LED on the control board is steady, relink the transmitter
and the V-Cam.
PROBLEM:
Flies with poor power or buzzes.
Solution:
One of the props may be bent. Carefully bend it straight.
PROBLEM:
With the battery disconnected, you notice that one of the
motors spins noticeably slower or feels tight.
Solution 1:
The motor may have slid down. Gently push the motor back
up into its mount.
Solution 2:
The prop may have slid down against the mount. Use a small
screwdriver to pry the prop upwards slightly.
Solution 3:
If the prop still turns slow, replace that motor boom. This is
done by removing the canopy, loosening the screw (9), unplugging the
motor, and pulling out the boom. Install the new boom in reverse order.
