H. Vollmer GmbH
ǀ
Allmendring 29
ǀ
75203 Königsbach-Stein
ǀ
www.HEITRONIC.de 3 / 8 02/22
GB Installation and operating instructions
LED recessed spotlight DL7002
Art. No.
500593, 500594
These operating instructions belong exclusively to the above-mentioned product. It contains important
information on the commissioning and handling of the luminaire. Therefore, please pay attention to these
operating instructions, even if you pass this product on to third parties. It is therefore important that you
keep these instructions in a safe place for future reference.
1. Introduction
Dear customer, thank you for purchasing our product. You have purchased a product from Vollmer, which has been
built according to the current state of the art. The luminaire meets the requirements of the applicable European and
national directives. In order to maintain the condition of the product and to ensure safe operation, you as the user
must observe these operating instructions!
2. Safety instructions
•
In case of damage caused by non-observance of these operating instructions,
•
the warranty claim expires!
•
We do not assume any liability for consequential damages!
•
If the lamp is damaged, it is strictly forbidden to put it into operation.
•
Do not allow children to play unsupervised in the area of the luminaires or other electrical devices.
•
During operation, the LEDs become hot. The outer lamp housing also becomes warm.
•
Do not bring the luminaire into contact with extreme heat or open flame.
•
Do not modify or alter the entire product. Modifications to the luminaire will void the warranty.
•
The type plate must not be removed.
3. Intended use
The luminaire is designed for indoor use
This product is for lighting purposes only and must:
•
only be operated with a voltage of 230V ~50Hz.
•
only be connected in accordance with protection class II (two).
•
only be operated firmly mounted on a stable, level and tilt-resistant base.
•
only be operated on normal or non-flammable surfaces.
•
not be subjected to strong mechanical stresses or heavy soiling.
4. Before installation/commissioning
•
The luminaire may only be operated outside its packaging.
•
Carefully remove the luminaire from its packaging.
•
Before operating the luminaire, make sure that it has not been damaged during transport. If there is any
damage to electrical parts, the lamp must not be operated. Repairs may only be carried out by a qualified
electrician.
•
Keep packaging material away from children and pets. Danger of suffocation!
5. Installation/Commissioning
•
This product may only be installed by a qualified electrician.
•
Before installation, the building's connecting cables must be disconnected from the power supply and
secured against being switched on again. To do this, trigger the corresponding circuit breaker of the building
installation.
•
Make sure that the substrate is suitable to support the weight of the LED spotlight permanently and reliably.
•
Saw out the installation dimensions at the desired position. Open the connection box of the luminaire.
•
Now connect the connecting cables of the house installation to the connecting terminals of the luminaire. As
a rule, the brown (or black) cable is the phase conductor, connect this to the terminal marked "L". The blue
conductor must be connected to the terminal marked "N". Close the connection box.
•
Do not kink cables; please ensure that cables and connectors are free from tensile and torsional forces.
Protect all cables and insulation from possible damage.
•
Check again that the connection is correct.
•
To fix the LED spotlight, use the permanently mounted retaining clips. Make sure that no cables are
damaged.
•
Switch on the circuit breaker of the house installation again.
