GB
IMPORTANT SAFETY INSTRUCTIONS
Make sure that all components are available. Closely follow the instructions in this manual. Keep the
instructions for later use. If you lend or pass on the solar light to someone else, also forward these
instructions.
Caution:
- Do not look directly into the LED light beam.
- Store the product in a place out of reach of children.
- This LED solar light is for outdoor use only.
- This article is not suitable for room illumination and it is only for motion-controlled outdoor lighting.
- The battery is integrated in the appliance. Do not try to open the appliance.
- Do not throw the appliance into fire. If you want to dispose it, please pay attention to the instructions
given under “ENVIRONMENTAL PROTECTION”.
- Clean the solar panel regularly to ensure that the battery is efficiently charged and the power on / off
functions work properly.
- The light source (LED) of this luminaire is not replaceable; when the light source (LED) reaches its
end of life the whole luminaire shall be replaced.
- This appliance is not suitable for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge unless they are supervised by a person
responsible for their safety or instructed on the use of the appliance.
- Children should be supervised that they do not play with the appliance.
LOCATION
- Find a suitable location with direct sunlight.
- Install the appliance on a wall at a height of about 2-2,5 meters.
- Adjust detection zone at swivel mount
CHARGING
- Charge the solar light in direct sunlight before using it for the first time.
- The charging process is not depend on the position of the ON / OFF switch (I / O).
BEFORE ASSEMBLING THE PRODUC
T
- Remove all packaging.
- Before assembling, check whether all parts listed in below parts list have been delivered. Do not start
assembling if parts are missing or damaged. In case of damage or incomplete delivery, please contact
your dealer (
Please see
WARRANTY).
- Select an open space in direct sunlight, where the solar panel will be exposed to the maximum
amount of sunlight during the day.
- Keep the assembly instructions to hand at all times and follow each of the individual steps exactly.
- Set the sensor distance, sensor delay time and brightness according to your needs.
INTENDED USE
- We assume no liability for accidents or damages caused by failure to comply with
the following instructions.
- This LED solar light is intended for outdoor use only.
PART IDENTIFICATION / SCOPE OF DELIVERY
- Plastic housing with hinged solar panel + two swivel-mounted LED spo ON / OFF switch (I / O)
+ knobs for sensor distance, sensor delay time and brig bracket with two screws.
ASSEMBLY
- Screw the bracket on the wall using two screws (included).
- Slide the light on the bracket.
- Lock the solar panel in a position where it will be exposed the most to sunlight.
USE
- Fully charge the device for the first use on three sunny days (see section charging!)
SENS TIME LUX
bracket
Wand
wall
Safety note:
Please make sure that no existing cables or lines (including water pipes) are damaged
when drilling in mounting holes or when tightening screws!
