GENESIS ESP NZAust v1.4 MW
Page
3
of
3
Concealed Wiring Option Instructions
:
The concealed wiring adaptor is to be installed
before
the wall cladding is in position.
1. Ensure that the flush box that the towel warmer will be wired to is within this distance of the mounting position of the
foot of the towel warmer that has the flex. Allow for loss of flex length due to connections.
2. Drill a 12.5mm hole into the face of the stud where the towel warmer foot with the flex is to be positioned. Drill the
hole approximately 25mm deep.
3.
Identify the side of the stud facing the flush box that the towel warmer will be wired to. On that side of the stud, drill
a 25mm deep hole at right angles to this first hole so that the hole will break into the base of the first hole. Refer to
Fig1.
9. Place a pull through line from the flush box to the 12.5mm hole that can be picked up later once the wall cladding is in
place
10. Once the wall cladding is positioned, remove some of the cladding to expose the 12.5mm hole. Locate the pull through
and thread the adaptor-fixing barrel onto the pull through.
11. Screw the adaptor fixing barrel into the stud. On masonry walls drill a 14mm hole and epoxy resin the adaptor-fixing
barrel into position. The shoulder of the barrel should leave a gap equal to the wall cladding thickness so that when the
wall cladding is fixed the shoulder of the barrel is flush with the wall cladding. (refer Fig 2)
12.
Mark a point horizontally from the centre of the adaptor at the measurement for your model (but check the actual
measurements to your warmer as manufacturing tolerances apply) for the other bottom fixing barrel. It is important that
the line between these two points is level
.
13. Screw the other fixing barrel (provided with the towel warmer) into place with the screw provided with the towel warmer.
14. Attach the pull through to the flex and pull the flex through the stud holes to the flush box.
15. Position the towel warmer on the bottom two fixing barrels and mark the two top feet. (Use easy to remove pencil)
16. Mark the centre distance for the top fixing barrels (per above) & screw the fixing barrels to the wall.
17. Remount the towel warmer on the four fixing barrels. Secure the foot containing the flex with the screw provided then
secure the three remaining feet with the screws provided.
At centre measurement for your model
