Heinzmann PANDAROS DC 6-06, Manual

Page: 11 / 96

2 General
Positioner DC 6-06
9
2.2.1 HEINZMANN Basic Software
The HEINZMANN basic software has the customer number x = 0 in each unit.
It is supplied in various different basic variants y = 0..99.
The change index z = 0..99 is a running index and is incremented by variant with every
new software release. Each higher index fully includes the lower index and
consequently supersedes it. At any given time there is only one valid version of a basic
software variant, namely the one with the highest current change index.
The following variants of the HEINZMANN basic software are currently supplied for
PANDAROS positioners.
Variant Firmware Meaning
DC 6-07 00.0.zz
Peripheral module with HZM CAN protocol
DC 6-06 00.1.zz
Positioner with setpoint selection
via analogue or PWM input
DC 6-12 00.2.zz
Elektra gas measuring unit with air/fuel ratio
control
Peripheral module with HZM CAN protocol
DC 6-13 00.3.zz
Speed and power-dependent
Gas positioner with misfire detection
DC 6-15 00.4.zz
Elektra gas measuring unit withgas flow control
DC 6-16 00.5.zz
Gas positioner with accelerator pedal manipulation
(idle/final speed governor in the diesel control unit)
DC 6-17 00.6.zz
Elektra gas measuring unit with lambda control
DC 6-18 00.7 .zz
Gas positioner with diesel injection time or diesel
position control
(variable speed governor in the diesel control unit)
Table 1 Basic firmware variants
This brochure describes the DC 6-06 positioner with setpoint selection by analogue or
PWM input
2.2.2 Custom firmware
Custom firmware always has an unique customer number x > 0. Once a customer
number has been assigned to a customer it remains dedicated to him and is used for
each custom software he orders, irrespective of the control unit that is used.
Different software variants y = 0..99 are created at the customer's request, e.g. for
different systems or different applications with one and the same control unit.