Heinner HMC-300BL, Manual

Page: 7 / 41

www.heinner.com 300W, 50Hz, 220-240V
6
Symptom Cause Analysis Troubleshooting
Power, press the
button, the product
does not work
No cover lid Replace the lid
The first few times
using the product,
the motor gives off
an unpleasant odor
The new motor is a normal
phenomenon originally used
If after repeated use, the product
continues to give off this smell, please
contact the point of sale for repairs
Stop use
1.The voltage is too low
2.The motor temperature
protection
1. Check the voltage is too low
2. Stop 20-30 minutes before use
Abnormal vibration
or noise
1. The cut is not in place
2.Product placement is not
stable
3. The voltage is too high
4. Food excess
1. Remove the food, will cut turret in place
2. Place the product stable
3. Check the voltage is too high4.
Disconnect the power, remove the excess
food
Stuck the knife
Blades are wrapped food or
stuck Disconnect the power, remove the food,
cut into small pieces
VI. CLEANING AND MENTENANCE
1. Before cleaning products, be sure to remove the body, disconnect the power.
2. Please use cleaning products.
3. When cleaning, use a rinse cup and accessories, and dry; very sharp blade, shredding
blade in the cleaning, do not hand in direct contact with the blade, in order to avoid
injury, clean water to clear, allowing you to clean the process can be seen in the blade.
4. Wipe the exterior with a damp cloth, do not put the body of water or other liquid, nor
rinse it under water or other liquids.
5. The product should be stored in a dry place and avoid direct sunlight.
6. Before storage products, make sure the product is clean and dry.
VII. TROUBLESHOOTING