Heinner HIS-D3007IX, Manual, Page: 23 / 56

www.heinner.com 3000W, 50/60Hz, 220-240V
V. USING INSTRUCTIONS
BEFORE FIRST USE
1. Remove any sticker, protective foil or storage cover from the soleplate.
2. Heat up the iron to maximum temperature and iron over a piece of damp cloth for
several minutes for the purpose of removing any residue on the soleplate according to
the section of “Steam ironing”.
NOTE: It is normal that strange odor comes out from the unit for the first use. This will
cease after a short while.
NOTE: Some particles may come out of the soleplate when you use the iron for the first
time. This is normal; the particles are harmless and stop coming out of the iron after a
short while.
NOTE: When you switch on the appliance, the steam station iron may produce a pumping
sound. This is normal; the sound tells you that water is pumped into the soleplate.
NOTE: During the heating process of the soleplate, there will be little steam coming out
from the soleplate automatically and this phenomenon will continue for about 3 seconds,
This is normal.
USING THE APPLIANCE
The appliance has two ironing ways. You can use dry ironing or steam ironing, the details
refer to the following:
Dry ironing
1. Put the iron on the thermal insulation stand of unit base.
2. Connect the plug to wall outlet and press down the power switch, the power indicator
turns on.
3. Turn temperature dial to your desired setting, which is depended on the fabric of
garment, and the temperature indicator will illuminate. The iron starts heating. Refer to
“IRONING TIPS” and “ADDITIONAL TABLE” as below when select temperature.
4. When the temperature indicator turns off, the selected temperature is reached. You
can start ironing now.
WARNING: Never touch hot soleplate at any time before cooling down!
Steam ironing
1. Grasp the water tank’s handle to remove the water tank, then fill it with water through
the filling aperture. You had better use purified water with less calcium particles. After it,
replace the water tank properly. The max capacity of water tank is 1.8L, the water level
shall not be exceeded the MAX mark.
2. Put the iron on the thermal insulation stand of unit base.
3. Connect plug to the wall outlet, press down the power switch, and the defaulted low
steam rate indicator will flash. And there are three modes including low, medium and
high steam rate available, you can select the desired steam rate for each garment
according to your requirement. Make sure that there is enough water in the tank.