Heinner HFSC-V50LITBK, Manual

Page: 51 / 128

www.heinner.com
50
Use of gas burners
Ignition of the burners
The position symbol above each control knob indicates the burner that the knob
controls.
Manual Ignition of the Gas Burners
If your appliance is not equipped with an ignition aid, or in case there is a failure in
the electric network, follow the procedures listed below.
For Hob Burners : Push in the knob of the burner you wish to ignite and keep it
pressed while turning it anti-clockwise
until the knob is in the ‘maximum’ position.
Continue pressing the knob and hold a lit match, taper or other manual aid to the
upper circumference of the burner. Move the ignition source away from the burner
as soon as you see a stable flame.
For Oven Burner : Push in and turn the oven control knob anti-clockwise until the
knob is in the ‘maximum’ position. Hold a lit match, taper or other manual aid to to
the ignition hole that is located on the front left corner of the burner. Move the
ignition source away as soon as you see a stable flame.
Flame safety device
Hob burners
Hobs equipped with a flame failure device provide security in case of an accidentally
extinguished flame. If such a case occurs, the device will block the burners gas
lines and will avoid any accumulation of unburned gas. Wait 90 seconds before re-
igniting an extinguished gas burner.
Oven / Grill (If available) Burners
Regardless of the model of your appliance, all oven burners are equipped with a gas
safety device. For this reason, during ignition, keep the oven knob pressed until you
see stable flames. If the flames are cut out after you release the knob, repeat the
ignition procedure. If the oven burner does not ignite after you keep the burner knob
pressed for 30 seconds, open the oven door and do not attempt re-ignition for at
least 90 seconds. If the oven flames go out accidentally, repeat the same procedure.
VII. USING THE PRODUCT