Heinner HFSC-50SW, Manual

Page: 27 / 92

www.heinner.com
26
VII. Connection and safety
1. Before installation, ensure that the local distribution conditions (nature and pressure of
gas) and settings adjustment device are compatible.
2. Conditions of adjustment for this unit are mention the energy label (or on the rating
plate identification).
3. This unit is not connected to a combustion products evacuation. Will be installed and
connected in accordance with regulations in terms of installation. Attention will be paid
to the applicable requirements venting incidents.
4. Fit the hose clamp. Push one end of the pipe until it touches the hose.
5. To check the seal: make sure the command buttons on the control panel are closed,
but the gas cylinder is opened. Apply some soap bubbles in the connection. If gas leaks
occur, the foam will form in the area.
6. The cooker must be in a well-ventilated room, on a flat surface.
7. Check the gas.
8. When you place the stove in place, make sure it is leveled. If needed, adjust the feet.
9. Do not leave gas hose near hot areas, especially in the back of the oven. Do not move
the appliance connected to the gas, because the force that can weaken the hose,
causing gas leaks.
10. Please use flexbile hoses to connect to the gas.
11. Sign in LPG cooker quickly and without risk of leakage. Min. 40 cm Max. 125 cm.
12. When you do check for gas leaks, never use lighters, matches, cigarettes or other.
Attention:
Do not close the lid when the burners are on.