Heinner HEM-1100BKRD, Instruction Manual

Page: 22 / 57

www.heinner.com 850W, 50-60Hz, 220-240V
21
4. Place an espresso cup you have prepared on drip plate. Make sure the steam knob is at the
“ ” position.
Note: As the appliance is not equipped with any cup or jug, prepare your own jug or cup.
5. Connect into power source, press down the ON/OFF button “ ” t o turn on the unit. The
power indicator (red) will be illuminated.
6. Press down the pump control button “ ”, th e pump will pump water, when there is water
flowing out and close the pump by pressing the pump control button “ ” again.
7. Make sure the coffee/ste am button“ ”/ “ ” is at the higher position and wait for a
moment, the appliance begin preheating until the coffee indicator (green) illuminates, it means
that the preheating is finished.
8. Press down the pump control button “ ” again, and water will flow ou t.
9. After water has flown for 1 minute, press th e pump control button “ ”, you can pour o ut
the water in each container then clean them thoroughly, now you can start brewing coffee.
Note: There may be noise when pumping the water for the first time, it is normal, as the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.
➢
PREHEATING
To make a cup of good hot Espresso coffee, it is recommended to preheat the appliance before
making coffee, including the funnel and cup, so that the coffee flavour will not be influenced by
the cold parts.
1. Remove the removable water tank and fill it with desired water, the water level should be
between the “MAX” mark and the “MIN” mark in the tank. Then insert the tank into the
appliance properly.
2.
Set steel mesh into metal funnel (no coffee in steel mesh), then put the metal funnel under
the metal funnel holder (see Fig.1), and turn it anticlockwise until it is fixed tightly (see Fig.2 and
Fig.3).
3.
Place an espresso cup you have prepared on removable cup shelf.
4. Then connect the appliance into power supply. Make sure the steam knob is at the “ ”
position.
5.
Pr ess the ON/OFF button “ ” to turn on the unit, the power indicator (red) will illuminate,
make sure the coffee/steam button“ ”/“ ” is at t he higher position.
6. Press down the pump control button“ ” to the lower position, when th ere is water flowing
out, close the pump immediately by pressing the pump control button“ ” again to the higher
position. The purpose of the step is to pump the water of the tank into the housing.