Heinner HEM-1050SS, Manual

Page: 20 / 50

www.heinner.com 1050W, 50Hz, 220-240V
19
6. After about one minute, turn the operation knob to the “O” position to stop brewing,
you can pour the water in container out then clean them thoroughly, now you can start
brewing.
Note: There may be noise when pumping the water on the first time, it is normal, the
appliance is releasing the air in the appliance. After about 20s, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, it is recommended to preheat the appliance
before making coffee, including the funnel and cup, so that the coffee flavour will not be
influenced by the cold parts.
1.
Remove the water tank and fill it with desired water, the water level should be between
the “MAX” mark and the “MIN” mark in the tank. Then insert the tank into the appliance
properly.
2. Set steel mesh into metal funnel (no coffee in steel mesh), then put the metal funnel
under the metal funnel holder, and turn it anticlockwise until it is fixed tightly.
3. Place an espresso cup you have prepared on removable cup shelf.
4. Then connect the appliance into power supply. Make sure the steam knob is at the "O"
position.
5. Press the ON/OFF button “ON ” to turn on the unit, the power indicator (red) will
illuminate, make sure the coffee/steam button“ ”/“ ” is at the higher
position.
6. The appliance will start heating.
7. Press down the Coffee/steam switch to the higher position which is the “ ” position,
waiting for a moment, until the ready indicator lights, it shows the pre-heating is finished.