10
Filling the detergent
Push the latch to open the dispenser and pour in the detergent.
Close the lid and press it until it locks in place. The dispenser should be refilled just before the
start of each programme. If the dishes are heavily soiled, place additional detergent in the
pre-wash detergent chamber.
Using combined detergents
These products should be used
according to the manufacturer’s instructions.
Never put combined detergents into the interior section or the cutlery basket.
Combined detergents contain not only the detergent but also rinse-aid, salt replacement
substances and additional components depending on the combination. We recommend you do
not use combined detergents in short programmes.
Please use powder detergents in such programmes.
If you encounter problems when using combined detergents, please contact the detergent
manufacturer.
When you stop using combined detergents, make sure that water hardness and rinse aid
settings are set to the correct level.
Rinse-aid usage
The rinse aid helps to dry the dishes without streaks and stains. Rinse-aid is required for
stain-free utensils and clear glasses. The rinse aid is automatically released during the hot rinse
phase. If rinse aid dosage setting set too low, whitish stains remains on dishes and dishes do
not dry and washed clean.
If rinse aid dosage setting set too height, you can see bluish layers on glass and dishes.
Filling The rinse-aid and setting
To fill the rinse aid compartment, open the rinse-aid compartment cap. Fill the compartment
with rinse aid to the MAX level and then close the cap. Be careful not to overfill the rinse aid
compartment and wipe up any spills.
In order to change the rinse aid level, follow the below steps before turning on the machine:
•
Open the door of the machine.
•
Turn on the machine, and press the Programme button as soon as the machine is
turned on.
•
Hold down the Programme button until “rA”
disappears. Rinse aid setting follows
water hardness setting.
•
The machine will display the last setting.
•
Change the level by pressing the programme button.
•
Turn off the machine to save the setting.
The factory setting is
“4”.
