Heinner HCVH-Y2300D, Manual

Page: 19 / 45

www.heinner.com 1000/1300/2300W, 220-240V~50Hz
OPERATION
Warning! Ensure that there is sufficient distance from the wall, fixtures or other
appliances. The distance must be at least 1.5 m from the front and sides wall of the
appliance to exclude the risk of fire.
1. Take the appliance and all the accessory parts out of the packaging.
2. Check that the appliance shows no signs of damage.
3. Select a location that is firm, level and incombustible.
4. Insert the mains plug into a suitable wall socket with 220 – 240 V~50/60Hz and be
sure power switch is on “OFF” position.
Operation instruction:
1.
Remove heater products and spare parts from the paper box, place on firm level
ground or desktop.
2. Before inserting the plug into an electrical outlet, make sure that the electrical supply
in your area matches that on the rating label on the unit.
3. Setting the master button to “off”. Plug the cord set into a 220-240v~AC electrical
outlet.Turning the master button “on” position.
4. Turn the heater ON by pressing the ON/OFF main button.The unit will display the
current Room temperature.
5. And then by pressing the “ ”button to start the unit.
6. Under mode 1000W/1300W/2300W, pressing the “ ” and “ ” button to increase
or decrease the temperature setting. It starts to heat when the environment
temperature below 2°C than the setting temperature. It will stop heating as soon as
reach the setting temperature. The setting temperature range is 5-37°C.
7. Pressing “ ” button to get heat directly. One time pressing is in 1000W setting, two
time pressing is 1300W setting, three time pressing is 2300W and four time pressing
is Prevent Frost setting. Prevent frost: after choose this mode, icon is lighted,
environment temperature is 5°C, 1000W heating element works, at the same time
“1000W” icon light. When the environment is 4°C, 1300W heating element works, at
the same time “1300W” icon light. When the environment ≤3°C, 1000W and 1300W
heating elements work at the same time, “2300W” icon light. When the environment
≥6°C, thermal fuse stop heating, icon crush out, only prevent frost icon light.
8. By pressing “ ” you can set the timer from 1-24 hours.
9. By pressing “ ” could choose open or close fan, the fan icon will be lighted on the
screen when the fan is working. Only under 1000W/1300/2300W mode, could open or
close the fan. Under other mode, cannot use fan. Switch to other work condition, the
fan will automatically shut off.