Heinner HCF-145NHA+, Manual

Page: 22 / 53

www.heinner.com
21
Fig. 4
X. LOCATION
The appliance should be installed well away from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabinet and the wall unit must be at
least 100 mm. Ideally, however, the appliance should not be positioned below overhanging
wall units.
Warning! It must be possible to disconnect the appliance from the mains power supply; the
plug must therefore be easily accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the rating plate
correspond to your domestic power supply. The appliance must be earthed.
The power supply cable plug is provided with a contact for this purpose. If the domestic
power supply socket is not earthed, connect the appliance to a separate earth in compliance
with current regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above safety precautions are not
observed.
First use / Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories
with lukewarm water and some neutral soap so as to remove the typical smell of a brand
new product, then dry thoroughly.
Important! Do not use detergents or abrasive powders, as these will damage the finish.
Temperature setting
Set the temperature, on the temperature control knob.
Position 1
– Cold Position
Position 5 – Colder. Normally setting at this position
Position 7 – Coldest
Position Max – To fast freeze much hot food, after using the freezer for 24 hours reset the
freezer to your desired setting.
The appliance may not operate at the correct temperature if it is in a particularly hot or if
you open the door often.