Heinner HC-290A+, Instruction Manual

Page: 27 / 66

The food is too warm.
Interior lighting does
not work.
Unusual noises.
The compressor does
not start immediately
after changing the
temperature setting.
Water on the floor or
storage shelves.
Temperature is not properly
adjusted.
Door was open for an
extended period.
A large quantity of warm food
was placed in the appliance
within the last 24 hours.
The appliance is near a heat
source.
Light bulb is defective.
Door seal is not air-tight
(possibly after reversing the
door).
Appliance is not level.
The appliance is touching the
wall or other objects.
A component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
This is normal, no error has
occurred.
Water drain hole is blocked.
Please look in the “initial Start Up”
section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the “installation
location” section.
Please look in the “changing the
Light Bulb “section.
Carefully warm the leaking
sections of the door seal with a
hair dryer(on a cool setting). At
the same time shape the warmed
door seal by hand such that it sits
correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.
The compressor starts after a
period of time.
See the “cleaning and care”
section.
Warning!
If the LED light bulb is
damaged, only a qualified electrician
of competent person must carry out
it!
Changing the light bulb
Heavy build-up of
frost, possibly also on
the door seal.
9
Changing the LED light bulb carry out by
inexperienced persons may cause injury or
serious malfunctioning. it must be replaced
by a qualified persons in order to avoid a
hazard. Contact your local Service Force
Center for help.
Before changing the light bulb, switch
off the appliance and unplug it, or pull
the fuse or the circuit breaker.
LED light bulb data: 220-240 V.
To switch off the appliance, set the
temperature regulator to position “0”.
Unplug the mains plug.
Press the bulb in the center with finger.
Take out the lampshade with “1” type
screwdriver, change the bulb, and then
replace the lampshade.
Put the refrigerator back into operation.