Heinner ECOMATE HVC-M1400RD, User Manual

Page: 20 / 54

www.heinner.com 1400W, 50/60Hz, 220-240V
19
Cleaning the exhaust air filter or HEPA filter
The exhaust air filter or HEPA filter cleans the air a final time before it leaves the vacuum
cleaner. You can clean the exhaust air filter or HEPA filter as follows:
1. Switch off the vacuum cleaner and disconnect the plug from the mains. To do this
always pull on the plug and not on the cable.
2. Open the exhaust air grill.
3. The exhaust air filter or HEPA filter is visible when the grill has been opened.
4. Rinse the filter or HEPA filter under cold running water and allow dry.
5. Put the exhaust air filter or HEPA filter back into place (or replace with a new one)
6. Close the exhaust air filter grill.
VII. ADVICES
Note: The sponge filter material in the cleaner will became dusty over time. This is normal
and will not affect the performance of the filter. If the sponge filter is so dusty that suction
does not return to 100%, then we suggest that the filter be removed then rinsed under
the faucet and allowed to dry for 24 hours by airing not near the fire or some high
temperature objects before refitting into the vacuum. This should be done once six
months or when suction appears to be reduced obviously.
Important: Please note that there is a safety valve inside the vacuum to prevent the unit
from being run with high vacuum rate. If the vacuum is too high ,the safety valve will be
turned on. In this case, it can minish the vacuum rate and protect the motor from being
broken.
Note: The suction hole must be open, free of any obstructions at all times. Otherwise, the
motor will overheat and could become damaged.