Heinner DCH-650RGBK, Manual

Page: 9 / 55

www.heinner.com 190W, 50Hz, 220-240V
8
FAULT POSSIBLE CAUSE SOLUTION
Light on, but motor does
not work Fan switched turned off Select a fan switch position
Fan switch failed Contact service center
Motor failed Contact service center
Light does not work, motor
does not work House fuses blown Reset/Replace fuses
Power cord loose or
disconnected
Refit cord to power outlet.
Switch power outlet on.
Oil leakage One-way valve and the air
ventilation entrance are not
tightly sealed Take down the one-way valve
and seal with sealant.
Leakage from the connection of
U-shaped section and cover Take U-shaped section down and
seal.
Lights not working Broken/Faulty globes Replace globes as per this
instruction.
Insufficient suction The distance between the cooker
hood and the gas top is too far Refit the cooker hood to the
correct distance.
The cooker hood inclines The fixing screw not tight enough Tighten the hanging screw and
make it horizontal
NOTE: Any electrical repairs to this appliance must conform to your local, state and federal
laws. Please contact the service centre if in any doubt before undertaking any of the above.
Always disconnect the unit from the power source when opening the unit.
Push button
a. Press the button “STOP”, the motor is stopped then.
b. Press the button “LOW”, the motor is running at low speed.
c. Press the button “MID”, the motor is running at medium speed.
d. Press the button “HIGH”, the motor is running at high speed.
e. Press the button “LIGHT”, both lights start shining. Press the button again, the lights
are switched off.
VI. USING THE APPLIANCE
VII. TROUBLESHOOTING