8
Instruction manual / EasyGrinder
5 Assembly and function
5.1 Assembly
1 Grinding disc with emery papier, 1 EasyPendulum, 1 safety glasses, ear plugs,
1 allen key, 1 instruction manual.
The actual scope of delivery can differ from specially designed models, from
additional ordering options or due to the latest state of the art from the here described
annotations and illustrations.
The EasyGrinder is dispatched fully assembled, however it must be set up before
being used for grinding, for full setup instructions refer to chapter 6 Operation.
5.2 Disc guard
The EasyGrinder is fitted with a guard enclosing the disc to protect the user during
use. It is necessary to remove the outer part of the guard to remove or to change the
emery papier. The guard is secured with four screws. When refitting the guard, always
use all four screws, tightened securely.
5.3 Disc and pendulum
The special light weight aluminium alloy discs and pendulum are precision tools
and will ensure the best possible edge on your gear and will give you years of great
service provided that you treat them with care. It is important that the disc is not
damaged or neglected, this can make it unusable.
ATTENTION !
The discs may be hazardous if used in a damaged condition. If the disc becomes
damaged it must be replaced. Just use original emery paper and discs of Heiniger.
The grinding disc is not fixed at delivery und must be fitted correctly onto the motor.
The disc must be protected at any time of crushes, hits and falling. Do not use to
much force to take off the disc and emery paper of the grinder.
5.4 Fitting the disc on the motor
Unplug the grinder from power before proceeding. The disc must be free of dirt, dust
or any other foreign matter.
Slide the disc onto the shaft of the motor. Fit the disc washer and nut on the shaft with
the enclosed spanner.
NOTE
The discs fitted to the grinder have been individually checked for balance.
It must be noted that it is possible for the emery to throw the balance off (see 9,
Troubleshooting).
