1. Attach the pump bracket [#8] to the bracket [#9] on
the side of the crane using two 3/8” x 3/4” flange head
bolts [#10] and two 3/8” nuts [#11] as shown in Figure
4. Be sure to attach the pump bracket [#8] to the bot
-
tom set of keyhole slots in the bracket [#9].
2. Mount the air pump [#12] to the pump bracket [#11] as shown
in Figure 5. Use two 3/8” x 1” bolts [#13] and 3/8” nuts [#14] to
secure the reservoir end of the air pump [#12]. The opposite end
of the air pump [#12] is attached to the pump bracket [#11] using
two 5/16” x 3/4” bolts [#15] and two 5/16” lock washers [#16].
The 5/16” x 3/4” bolts [#15] thread into tapped holes in the air
pump [#12].
3. Attach the S-hook [#17] to the hole in the pump
bracket [#11] as shown in Figure 6.
4. Route the air hose [#18] through the S-hook [#17].
The S-hook [#17] can be closed around the air hose
[#18], if desired. Be careful to not pinch or cut the air
hose [#18] when closing the S-hook [#17]. Otherwise,
the S-hook [#17] can be left open so the air hose
[#18] can be inserted or removed from the hook as
desired. The purpose of the S-hook [#17] is to provide
a location to hang the air hose [#18] that prevents it
from dragging on the floor.
5
Figure 4
Figure 5
Figure 6
