HEIDENHAIN TNC 426, User Manual

Page: 171 / 502

HEIDENHAIN TNC 426, TNC 430 145
6.4 P
a
th Cont
ours — Car
tesian Coor
dinat
e
s
Circular path CR with defined radius
The tool moves on a circular path with the radius R.
U
Coordinates of the arc end point
U
Radius R
Note: The algebraic sign determines the size of the
arc!
U
Direction of rotation DR
Note: The algebraic sign determines whether the arc
is concave or convex!
Further entries, if necessary:
U Miscellaneous function M
U Feed rate F
Full circle
For a full circle, program two CR blocks in succession:
The end point of the first semicircle is the starting point of the second.
The end point of the second semicircle is the starting point of the first.
Central angle CCA and arc radius R
The starting and end points on the contour can be connected with four
arcs of the same radius:
Smaller arc: CCA<180°
Enter the radius with a positive sign R>0
Larger arc: CCA>180°
Enter the radius with a negative sign R<0
The direction of rotation determines whether the arc is curving
outward (convex) or curving inward (concave):
Convex: Direction of rotation DR– (with radius compensation RL)
Concave: Direction of rotation DR+ (with radius compensation RL)
Example NC blocks
or
or
or
10 L X+40 Y+40 RL F200 M3
11 CR X+70 Y+40 R+20 DR- (arc 1)
11 CR X+70 Y+40 R+20 DR+ (arc 2)
11 CR X+70 Y+40 R-20 DR- (arc 3)
11 CR X+70 Y+40 R-20 DR+ (arc 4)
X
Y
CC
S
1
=E
2
E
1
=S
2
R
X
Y
40
40 70
DR+
4
ZW
3
R
R
X
Y
ZW
R R
40
40 70
1
2
DR+