1
IK 5000 QUADRA-CHEK
English
Installation and Setup
For detailed description, see
www.heidenhain.de
Before Power up
Caution
•
Mounting and commissioning is to be
conducted by a specialist in electrical
equipment and precision mechanics
under compliance with local safety
regulations.
•
Do not engage or disengage any
connections while under power.
•
The drive must not be put into
operation during installation.
Danger of electrical shock!
•
Never work in an open enclosure
when power is connected.
Disconnect the power cable before
opening the enclosure.
•
Never use 3-wire to 2-wire adapters
or allow the ground connection to
the IK 5000 PC to be interrupted or
disconnected.
Caution
Do not connect encoders or other
equipment to the IK 5000 when the
power is on.
Safety Considerations
Accepted local safety regulations
must be followed when operating
the IK 5000. Failure to observe these
regulations could result in damage to
the equipment, or injury to personnel.
It is understood that safety rules within
individual companies vary. If a conflict
exists between the material contained
in this guide and the rules of a company
using this system, the more stringent
rules should take precedence.
Using this Guide
This guide includes installation and
setup instructions for all standard
IK 5000 products, therefore only certain
of the instructions will apply to your
specific system. Follow the installation
and setup instructions in the order
presented, and skip steps that do not
apply to your system.
PC cards, Flyouts and
Connectors
Diagrams on the preceding pages
show IK 5000 PC cards, flyouts and
connectors for all standard IK 5000
systems. As shown in the diagrams,
some external connections are made
directly to the IK 5000 PC card, others
are made to the card though flyout
connectors.
While certain PC cards, flyouts and
connectors are common to multiple
IK 5000 products, others are unique
to specific members of the IK 5000
product family. The IK 5494-3D PC card,
flyout for K and M connectors and a
typical PC connector configuration are
shown below as examples.
PC card for IK 5494-3D
K and M flyout for IK 5494-3D
Typical PC card and flyout
connectors at the rear of a PC
IK 5000 connectors are shown in the
diagrams of preceding pages. Connector
pin wiring is shown at the end of this
guide.
Connector Description
A
X, Y and Z Encoder and foot
switch inputs
B
X, Y and Z axis CNC control
outputs
C
IK 5000 card connection to
Flyout
connectors H and J
D
IK 5000 card connection to
Flyout
connector K
E
IK 5000 card power connector
F
IK 5000 card connection to
Flyout
connector N
G
IK 5000 card PCI connector
to
PC motherboard
H
Q axis encoder input
J
Q axis CNC control output
K
Video light outputs
M Touch probe input
N
Camera zoom control output
P
Comparator light source input
for optical edge detection
R
Comparator screen sensor
input
for optical edge detection
T
Optical daughter board optical
cables
through connectors P and
R to the comparator light source
and screen sensor
V
TP200 daughter board
connection to flyout
connector M
W RS-232 PC motherboard
connector
Note
The instructions in this Quick Reference
Guide are intensionally brief. Refer
to the
IK 5000 OEM Setup Guide
at
www.heidenhain.de
for detailed
instructions.
Very important
Please note
For your information
