HEIDENHAIN GAGE-CHEK 2000 Series, Operating Instructions Manual

Page: 183 / 236

Settings |
General
11.2.8
Units
Path: Settings
►
General
►
Units
Parameter Explanation
Unit for linear values Unit of measure for linear values
Settings: Millimeters or Inch
Default setting:
Millimeters
Rounding method for linear
values
Rounding method for linear values
Settings:
Commercial
: Decimal digits from 1 to 4 are rounded down,
decimal digits from 5 to 9 are rounded up
Round off : Decimal digits from 1 to 9 are rounded down
Round up
: Decimal digits from 1 to 9 are rounded up
Truncate : Decimal digits are truncated without rounding up
or down
Round to 0 and 5 : Decimal digits
≤
24 or
≥
75 are rounded to
0, decimal digits
≥
25 or
≤
74 are rounded to 5
Default setting: Commercial
Decimal places for linear values Number of decimal places for linear values
Setting range:
Millimeters : 0 ... 5
Inch
:
0 ... 7
Default value:
Millimeters : 4
Inch : 6
Unit for angular values Unit for angular values
Settings:
Radian
: angles in radian (rad)
Decimal degrees : angles in degrees (°) with decimal places
Deg-Min-Sec : angles in degrees (°), minutes ['] and
seconds ["]
Default setting:
Decimal degrees
Rounding method for angular
values
Rounding method for decimal angular values
Settings:
Commercial : Decimal digits from 1 to 4 are rounded down,
decimal digits from 5 to 9 are rounded up
Round off : Decimal digits from 1 to 9 are rounded down
Round up
: Decimal digits from 1 to 9 are rounded up
Truncate : Decimal digits are truncated without rounding up
or down
Round to 0 and 5 : Decimal digits
≤
24 or
≥
75 are rounded to
0, decimal digits
≥
25 or
≤
74 are rounded to 5
Default setting: Commercial
11
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020
183