ACCESSORIES
Please notice our extensive range of reflectors, umbrellas, softboxes, stands and other accessories.
Visit us on
www.hedler.com
HEDLER WARRANTY
All Hedler equipment is fully guaranteed against any material or manufacturing defects for three years after date of purchase. Parts made out of
glass, fuses, halogen bulbs, flash tubes, Pyrex
®
coverings and single cell LED modules are not covered by this warranty.
MAINTENANCE and REPAIR
For a secure operation of light units they have to be maintained. Therefore: before using light units they have to be checked visually and an
electrical safety check has to be done every twelve month. The results of this check have to be documented and archived. If you have any
questions about the safety check, please fell free to contact us.
0049(0)6482-918100
www.hedler.com
If repair is required, please, contact your dealer, the authorized distributor in your country or the Hedler factory directly. Please note, that a
pre-dismantled light unit could cause increased repair costs.
CHECK
All HEDLER light units are tested at HEDLER Systemlicht GmbH according to DIN 0701/0702 with protocol I. This check has to be repeated
yearly. Please contact us.
0049(0)6482-918100
www.hedler.com
PLEASE NOTE - SPECIAL SET-UP ADVICE
Light units of the HEDLER DX- and DF-range have an up side and an underside, setting-up the light unit it is important to take care of the correct
position of these sides. The light unit(s) is/are set-up correctly, if the QuickFit Adapter (located at the front side of the housing) is located beneath
the bulb respectively the safety glass (as shown on the photograph) or the Fresnel lens.
To ensure a continuous operation, the light units of the HEDLER DX- and DF-range have to be set-up / operated in the position described
respectively as shown on the photograph.
If you take the light unit in operation in an upside-down set-up, the internal automatic temperature safety switch will (according to the ambient
conditions) switch off the light unit after some operation time until it has cooled down. This is not a failure or a maloperation of the light unit(s)
of the HEDLER DX- and DF-range, it is a protection shutoff for the internal electronic ballast to prevent overheating.
Set-up correctly - shown for the HEDLER DX15.
H E D L E R S y s t e m l i c h t G m b H H e e r s t r a s s e 1 1 2 D - 6 5 5 9 4 R u n k e l / L a h n w w w . h e d l e r. c o m
Te l e f o n + 4 9 - ( 0 ) 6 4 8 2 9 1 8 1 0 0 Te l e f a x + 4 9 - ( 0 ) 6 4 8 2 9 1 8 1 1 1 e M a i l i n f o @ h e d l e r. c o m
Daylight DX15 / DF 15
HEDLER
®
S y s t e m l i c h t
OPERATION MANUAL
