Telephone 0045 75891244
- for professionel farmes
24
11.2 Weekly cleaning and maintenance
Before cleaning the machine disconnect electricity and pneumatic air.
1. After use clean the machine with pneumatic air.
2. Empty water separator (1).
3. Check the oil level in the pneumatic lubricator and replenish after
need (2).
Always
use the right air oil: Statoil NUTO H 15.
Hedensted Gruppen – item no. 476550
4. Shears and slippery surfaces are dried clean and oiled with fine oil.
Hedensted Gruppen – item no.476590
5. The lubricating nipples of the shears are oiled with grease.
Hedensted Gruppen – Item no. 476570 (Patron 400g)
11.3 Storing of the HG Combi Cut
To obtain a long lifetime and good reliability by starting up, it is necessary
to clean the machine well and make an extra oiling. The slicing machine is
cleaned as described under daily/weekly cleaning.
Shears and slippery surfaces are dried and oiled with fine oil
Hedensted Gruppen item no. 476590
The lubricating nipples of the shears are oiled with grease.
Hedensted Gruppen item no. 476570 (Patron 400g)
Oil the air engines extra well by opening the pneumatic lubricator and run
a couple of times with the machine.
Remember: To close completely for the pneumacit lubricator again, and
then open 1 round then it is ready for next season.
Always use the right air oil: Statoil NUTO H 15.
