HP103 Plasma Torch Height Controller
- - 7 - -
Mode 2
：
When the Arc-ON signal with
“
EAON
”
(the Arc-On
signalwithout IHS) is available, the height controller will not process
the IHS but control the plasma to Arc-on directly; the height
controller will send the signal of arc transfer and pierce transfer to
the NC system after producing the transfer arc. At the mean time,
the controller delay time to put the arc voltage into the single chip
system. If
“
Auto Permitted is available in height controller and NC
system has sent out AUTO height adjusted signal, the controller is
on status of
“
Height Auto adjusted
ATTN: When the NC system that you use can not receive the
signal of arc-on and pierce, please delay the time to control the NC
system
’
s running. It just means that the NC system send arc-on
signal to the height controller, delay time to run the NC system.
3.2 INSTALLATION CONTROLER
：
The following section provides you with the procedure to follow
when installing the HP103. Some of the steps direct you to other
sections in this manual that provide you with more detailed
instruction.
1. Determine a mounting location for the HP103. Keep the
following points in mind:
To avoid overheating and potential damage to the control box
from cutting process fumes, DO NOT choose a mounting location
C
re
at
ed
in
M
as
te
r P
D
F
Ed
ito
r