HP103 Plasma Torch Height Controller
- - 6 - -
2.4 Operation panel
Arc Voltage
Before Arc Start it shows the Set Arc Voltage.after it shows the
Actual Arc Voltage
3. INSTALLATION
3.1 working process:
Mode 1: When the Arc-ON signal with
“
IAON
”
( the Arc-On signal
with IHS) is available , the height controller should process the IHS
firstly; Secondly auto-control the Arc-on, the height controller will
send the signal of arc transfer and pierce transfer to the NC system
after producing the transfer arc. At the mean time, the controller
delay time to put the arc voltage into the single chip system. If
“
Auto
Permitted is available in height controller and NC system has sent
out AUTO height adjusted signal, the controller is on status of
“
Height Auto adjusted
”
HIS Height
Piercing Delay
IHS TEST
Arc Test
Arc Voltage
Up
Down
Set Voltage
Down
Up
Arc On
Auto
Trans
Collision
Auto/Manual
C
re
at
ed
in
M
as
te
r P
D
F
Ed
ito
r