O
THER
P
OTENTIAL FAULTS
odour, smoke or spark
omitted on initial use
Strange sounds, odour, white
smoke omitted on initial use
Strange sound while igniting or
flameout
Flame or Sparkle appearing
from the outlet during ignition.
This is normal. Because at the beginning
there are air and dust mixed in the burning.
Wait for some time they will disappear.
When the air in the pipe is expelled, the
phenomenon will disappear.
The metal parts of the heater expand and
contract causing the noise. This is normal.
Fuel and air of last time were left in the oil
pipe of the nozzle, so the air and fuel are
not proper mixed, the burning isn’t
continuous. Sparkle is caused by the
residual carbon powder. This is normal.
11
Trouble Shooting
Please use the guide below before returning the product.
S
YMPTOM
/P
ROBLEM
Heater does not start
No power
Power-cut
Smoke/dust/fire from outlet
Low Voltage
Wrong Frequency
The quality of fuel is bad
Filter blocked
Water is mixed in the tank
Flame goes out while burning
Fuel tank air hole blocked
Fuel exhausted
Filter blocked
Flame does not ignite
Water is mixed in the tank
Fuel leaks
Fuel drain screw loose
S
OLUTION
Make sure the power is connected
Switch the unit on when power is restored
Ensure unit is supplied the correct voltage
Use the defined frequency on Rating Label
Clean fuel tank and refill fresh fuel
Check and replace the filter
Clean the fuel tank
Clean the hole on the fuel tank cap
Fill the tank with fuel
Check and replace the filter
Clean the fuel tank
Tighten the screw
HSFAH30_instructions 13/7/15 12:55 Page 11
