HeatSeeker VORTEXC, Installation & User Manual

Page: 23 / 32

8.3 INSTALLATION INSTRUCTIONS
8.3.1 Mounting
Find a suitable location to mount the VortexSwitch box. Ideally as with all pool equipment it should
be installed out of direct weather and no closer than 3m from the water’s edge and a minimum of
600mm above ground. Lift up the two mounting tabs and use two appropriate screws to mount the
VortexSwitch box to the wall, keeping in mind that the power cable is 1.8m long and should be plugged
directly into a general power outlet, not into an extension lead.
8.3.2 Pump
The circulation pump plugs into the 240V outlet beneath the VortexSwitch.
8.3.3 Heating Priority
Connect the heating priority cable from the VortexSwitch to the heat pump, refer to the heat pump
manufacturer’s instructions and the below diagram for the appropriate connection and note that
damage caused by incorrect connections will void warranties.
Control Wire
Power supply
230V ~ / 50Hz
Potential free Dry Contact
P1 P2
Heatseeker VortexC Inverter Heat Pump
Installation & User Manual
21