Heatrae Sadia SUPREME 150SS, Fitting Instructions And User Manual

Page: 5 / 20

5
2.0 INSTALLATION - MOUNTING
2.1 The Supreme must be vertically wall mounted using the bracket
supplied. Special precautions may be required for the protection
of children and/or infirm persons. The appliance is not intended
for use by young children or infirm persons without supervision.
Young children should be supervised to ensure that they do not
play with the appliance.
2.2 Fig.2 details the outside dimensions of the Supreme unit. A
template is supplied to aid positioning the heater. It is
recommended that the unit is positioned above a draining board.
If this is not possible consideration should be given to any
spillages that may occur under the heater. A drip tray is
available as an accessory (Heatrae Sadia Code No. 95 970
123). The heater should be positioned at a height to suit the
items being filled (flasks, pans, cups etc.). This is likely to
position the base of the unit 250mm above the work surface.
2.3 Sufficient room should be left around the heater for access for
maintenance and servicing. The top should not be covered as
this will reduce the efficiency of the Supreme.
2.4 Ensure that the wall can support the full weight of the unit (see
TECHNICAL SPECIFICATIONS) and that there are no hidden
services (electricity, gas or water) below the surface of the wall.
2.5 Using the template mark the fixing positions and water and vent
entry points. Drill and plug the fixing positions. Fix the mounting
bracket to the wall using the two No.12 x 2” screws provided
(
confirm suitability of all screws and plugs for use with the
wall, if unsuitable due to wall type provide alternative
fixings
).
2.6 If rear entry services are to be used the necessary holes for these
should be prepared prior to hanging the unit onto its bracket.
2.7 Remove the front cover by: unscrewing the cover fixing screws
(two at the bottom), hinging the cover slightly forward and then
lifting it clear. Hang the Supreme onto the wall mounting bracket.
Secure anchor point to the wall with the No.8 x 1” long screw
(provided).