12
6.4 Fitting cover
Fit outlet spout if required - see figure 10 p10.
Check that the flow control valve is fully closed by
turning the gear fully anti-clockwise.
Place the cover onto the back plate.
Secure the cover to the back plate using the screws
provided.
WARNING
This product must be earthed.
7. Commissioning
7.1 General
NOTE: The first operation of the product is intended
to ensure the heater unit contains water before the
product is switched on.
7.2 Checklist before commissioning
Before turning on the electricity and mains water to
the hand wash ensure the torx adjusting screw is
turned fully anticlockwise – see figure 15 below.
7.3 Commissioning procedure
`
Turn on the electrical supply and main water
supply at the isolating stop valve.
`
Place hand in front of appliance sensor to
activate solenoid.
`
When water flows constantly from spout turn
torx adjusting screw to an acceptable level of
flow, appliance will then start to heat water. (You
may have to place your hand in front of sensor to
keep water flowing) adjust further for acceptable
heat.
`
Leave torx adjusting key with customer.
8. Operation
8.1 General
Place hand in front of appliance sensor. After
approximately 15 seconds the water will start to heat.
Shut off the product by moving your hand away from
the sensor. The product is now ready to use.
The neon light will illuminate when the water is
heating.
Sprayplate
To remove sprayplate
unscrew anticlockwise
using a coin.
Ensure all holes in
sprayplate are clear.
It is recomended to soak
the sprayplate overnight
in suitable descalant.
DO NOT OVERTIGHTEN
when refitting sprayplate.
Figure 15
