Assembly instruction JUNO
3
Visualization of operating conditions of the electric heating element
LED 2,3,4,5 – signal the setting level ort he current heating temperature (30,40,50,60 C,
respectively)
LED1 – signals the operating condition of the electric heating element ( heating, setting,
timer, antifreeze and failure)
LED indicator condition
Operating condition of the electric heating element
LED1 – continuous red.
The electric heating element heats at the level signalled by other LEDs
LED1 – continuous blue
LED2 – continuous red
ANTIFREEZE function
LED1 – continuous blue
LED 2 to 5 - continuous dim red
Heating level setting condition
LED1 – continuous red
LED 2 to 5 - brightened up red
The electric heating element heats up to the set level. The continuous light of LED2 to 5
means reaching subsequent temperature levels. When the required temperature is
achieved, all LEDs illuminate continuously.
LED1 – continuous red
LED 2 to 5 - dim red
The electric heating element cools down, which means that the setting temperature is lower
than the current one.
LED1 – red / blue alternately
Problem with reading the temperature from the sensor
LED1 – continuous purple
“2 h back” timer – the dryer function is on
LED1 – flashing purple
“2 h off” timer – the dryer function is on
10. When the line voltage is recovered after its previous disappearance (mains failure, or the power plug was unplugged) and
the control is on, the electric heating element begins to operate in the condition in which it was operating prior to the voltage
disappearance.
11. The electric heating element is adjusted to operate with a standard timer.
Troubleshooting
If you assume that the electric heating element does not work properly:
1. Check any possible operating conditions of the electric heating element in the user manual (chapter V, point 9).
2. Check whether the electric heating element is correctly installed and connected to the mains.
3. Check the heating agent level in the radiator (the method of its filling up).
In case of any further irregularities, the electric heating element must be disassembled and returned to the seller.
Maintenance of the electric heating element
CAUTION! While cleaning the electric heating element with detergents or liquids, unplug the electric heating element.
Moreover, prevent the equipment controller from being poured.
EN
