background image

6

5

Wireless 

Series

Model

: PRT-W

Installation Procedure

This wireless thermostat is designed to be surface mounted.

Step 1

Carefully separate the front half of the thermostat from the back plate by placing a 

small flat head terminal driver into the slots on the bottom face of the thermostat.

Step 2

If you are installing a remote air temperature probe, terminate the thermostat as 

shown in the diagram on page 30.

Mark 2 hole positions on the wall using the backplate as a positioning template.

Drill at the marked positions and insert a wall plug into each hole.

Step 3

Screw the thermostat back plate securely on the wall.

Step 4

Clip the front of the thermostat back onto the thermostat back plate.

Do

Mount the thermostat at eye level.

Read the instructions fully so you get the best from our product.

Don’t

Do not install near to a direct heat source as this will affect functionality.

Do not push hard on the LCD screen as this may cause irreparable damage.

1

3

4

2

8

7

Wireless 

Series

Model

: PRT-W

Installing the Batteries

2x AAA batteries have been supplied with this thermostat.

To access the battery holder, push and release the compartment door located on 

the bottom face of the thermostat.

Insert the batteries in the empty battery holder, ensuring that each battery is 

orientated for the correct po / - .

Push the battery holder back inside the thermostat until it is secured

in its closed position.

10

9

Wireless 

Series

Model

: PRT-W

Pairing With the RC1-W Receiver

With the thermostat turned OFF:

• 

Press & hold the Clock button until you see two sets of numbers appear ...

• 

The small number 01 in the top right corner of the LCD is the feature number.

• 

Press Clock repeatedly until you see feature 06 (Receiver Type) ......................

The options within feature 06 are: 00 = UH1-W or 01 = RC1-W receiver.

• 

Use the Up/Down keys to set feature 06 to 01 (RC1-W) .............................

• 

Press Clock again until you see feature 07 (Receiver Address) .........................

• 

You can now select a Receiver Address from 01-32.

• 

Use the Up/Down keys to set feature 07 to 01 ...............................................

(You must set a unique receiver address for each receiver installed).

• 

Press Clock again until you see feature 08 (Zone number) ................................

• 

You are able to connect two PRT-W thermostats to one RC1-W receiver.

• 

Use the Up/Down keys to select the zone this thermostat

controls (01 or 02) ....................................................................................................

• 

Press A to confirm settings and the display will go blank ..................................

If using with the UH1-W wiring centre, turn to page 11.

Batteries have a fixed lifespan and will need to be replaced occasionally to

ensure the thermostat operates correctly.

The thermostat will inform you when the batteries need to be replaced by 

displaying the battery icon on screen.

 

Note: You must replace the batteries within 1 minute of removal in order to retain

the current clock and comfort level settings.

Replacing the Batteries

Battery Icon

(Flashes)

Reviews: