12
Pairing with the RF-Switch
Air
-M
neo
• Use the Left arrow key to highlight on the menu ...................................................................
• Press and hold for 3 seconds
..............................................................................................................
• SETUP is now highlighted, press once to access the setup menu.................................
• The display will show the number 01 in the top right hand corner.
• Press the Down arrow key once, P1 is displayed
in the top right corner..............................
• Press once
.....................................................................................................................................................
• The display will start counting down from 99, pairing mode is now active on the neoAir...
On the neoAir:
On the RF-Switch:
• Press and hold the CH1 button for 5 seconds, the CH1 light will start flashing, pairing
mode is now active on the RF-Switch.
• Once the RF-Switch detects the pairing signal from the neoAir, the CH1 light will turn off.
To control heating only, configure the neoAir in mode 1.
To control heating & hot water, configure the neoAir in mode 3. (See page 7)
• Pairing complete.
On the neoAir:
•
Press to confirm pairing, this will exit the setup menu and return to the main
display.................................................................................................................................................................................
Summary of Contents for NeoAir V2-M
