16
15
WiFi
Series
Model:
DT-TS WiFi RF
•
To pair the thermostat with the receiver, press and hold the
SCREEN button for 10 seconds .......................................................................
Pair Successful
The address of the receiver will flash on the thermostat display and the
Comms LED on the receiver will flash and then go out to indicate the
pair is successful.
•
Press DONE to confirm the pairing ................................................................
Pair Fail
If the Comms LED does not flash there is a problem with the RF signal and
you should reduce the distance between the thermostat and receiver.
Where possible ensure there are no metal objects blocking the signal.
Check features 06 - 08 have been configured correctly.
Comms LED
To pair the thermostat with the RC1-W receiver, follow these steps.
On the receiver;
Press and hold the pairing button until the communication LED lights up.
On the thermostat;
•
Press PROG and then SETUP .................................................................................
•
The small number 01 in the top right corner of the LCD is the feature number.
•
Use the Up key to select 06 (Receiver Type) .................................................................
The options within feature 06 are: 00 = UH1-W or 01 = RC1-W receiver.
•
Use the Up/Down keys to set feature 06 to 01 (RC1-W) ................................
•
Use the Up key to select 07 (Receiver Address) ..........................................................
•
You can now select a Receiver Address from 01-32.
Use the Up/Down keys to set the RC1-W Receiver address .........................
(You must set a unique receiver address for each receiver installed).
•
Use the Up key to select 08 (Zone Number) ................................................................
•
You are able to connect two WiFi RF thermostats to one RC1-W receiver.
Use the Up/Down keys to select the zone this thermostat
controls (01 or 02) ........................................................................................................
•
Press DONE to confirm and exit .......................................................................................
Pairing with the RC1-W Receiver
If using with the UH1-W wiring centre, turn to page 17.