GENERAL INSTALLATION INSTRUCTIONS
HEATITCABLE.COM
5
Key points of installation: remember to open the valve of cold
water pipe/hot water pipe/return pipe after installation.
DO NOT Mount Motor Shaft in Vertical Position
Commissioning
Panel description
Function description
Function name
Function description
Mode switch
Pump speed switch
Antifreeze protection
Smart constant temperature mode (orange light), energy-saving constant temperature
mode (green light), Manual mode (no light).
The product is divided into three gears. When running, the gear is indicated by the
rotating speed of the light bar. The faster the rotating speed is, the higher the gear is.
When the water temperature of the pipeline is lower than 5
℃
for 30s, the electric pump
will operate until the water temperature meets 10C. If the water temperature can’t meet
10C, a buzzer will sound to give an alarm.
Speed
Mode Set
8. Reopen the supply valve to the hot water heater and allow the water to run until all the air has been purged from
the piping.
9. Close faucet inside the house.
10. Plug the line cord of the pump into a 115V outlet. Be sure to route the power cord so that it does not touch the
exhaust vent piping of a gas or oil-fired hot water heater.
Mold name
Mold description
Smart constant
temperature mode
Energy-saving constant
temperature mode
Manual mode
When turned on, the icon lights orange, and the pump operates at constant
temperature throughout a day.
When turned on, the icon lights green, and the pump operates at an energy-saving
constant temperature state throughout a day.HEATIT Smart pump can decrease the
temperature setting point automatically if you didn’t use the hot water for some time.
When pressing the icon briefly in any state, the pump will stop after reaching the set
time or target temperature.