01-03
23
34613 Rev F
NOVUS SERIES INSTALLATION INSTRUCTIONS
b. Standing Pilot Ignition
1) Appliance Requirements
A wiring diagram is shown in Figure 42.
2) Wall Switch
The installer shall supply a UL-listed or in
Canada, a CSA-listed wall switch. This
appliance was tested with eighteen feet of UL
listed 18 ga. Type CL2 105°C, two conductor
thermostat wire. If other wiring materials are
used they shall comply with local codes. In
the absence of local codes, they shall comply
with the National Electric Code ANSI/NFPA
70-latest edition or Canadian electrical code
CSA C22.1
WARNING!
This standing pilot appliance DOES NOT require a
110V AC supply for operation. Connecting the
appliance/wall switch to 110V AC supply will cause
the appliance to malfunction and destroy the valve
and thermopile.
Figure 42
Standing Pilot Ignition Wiring Diagram
3) Optional Accessories Requirements
Wiring for optional accessories should be
done now to avoid reconstruction.
6. JUNCTION BOX INSTALLATION INSTRUCTIONS
a.
Remove the junction box assembly from the valve compartment.
b.
If the box is being wired from the OUTSIDE of the appliance:
1)
Loosen two screws on the Romex connector, feed the necessary length of wire through the connector and
tighten the screws.
2)
Make all necessary wire connections to the receptacle and assemble the receptacle and cover to the junction
box.
3)
Attach the junction box assembly to the outside of the appliance with the two screws provided.
c.
If the box is being wired from the INSIDE of the appliance:
1)
Pull the electrical wires from outside the appliance through this opening into the valve compartment.
2)
Loosen the two screws on the Romex connector, feed the necessary length of wire through the connector
and tighten the screws.
3)
Make all necessary wire connections to the receptacle and assemble the receptacle and cover to the junction
box.
4)
Attach the junction box assembly to the inside of the appliance with the two screws provided.
d.
If the box is not to be wired at the time of appliance installation, assemble the receptacle and cover to the box and
install on the inside of the appliance.