23
Heatilator • ECO-WINS18 • 7065-132D • November 22, 2011
E. Baffl e & Ceramic Blanket Removal
F. Door Handle Assembly
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install additional washer(s) as shown in
Figure 23.3.
4. Install key in groove.
5. Align groove in latch cam with key; slide latch cam over
shaft
6. Install locknut but do not overtighten, the handle needs
to move smoothly.
7. Install handle turning in a counter-clockwise motion to
desired location on door handle rod.
Figure 23.3.
CAUTION!
Do not overtighten lock nut. The door handle
needs to move smoothly.
Figure 23.1
Figure 23.3
Locknut
Door Cross Section
(example)
Latch Cam
Spacing
Washers
Square Key
Door Handle
Spring
Handle
1.
Remove all ash from the fi rebox, and extinguish all hot
embers before disposal into a metal container.
2. Remove the baffl e protection channel by rotating it down
from the front tube.
Figure 23.1.
3. The baffl e board has 2 pieces. With the ceramic blanket
still in place, slide one baffl e piece over the top of other
one and pull out top piece through the door opening and
then remove bottom baffl e piece.
Figure 23.2.
4. Remove the ceramic blanket.
5. Re-install the ceramic blanket and smooth out the blanket.
6. Slide the baffl e pieces one piece at a time underneath the
blanket. Be sure the baffl e boards are even with the front
manifold tube and is resting on all tubes.
Figure 22.1 and
22.2.
7. Re-install the baffl e protection channel by rotating it up and
around the front tube so the bottom fl ange of the channel
rests behind the manifold tube. The baffl e boards and
blanket are tucked inside the rear of the baffl e protection
channel.
2 pc Baffle Board
Manifold Tubes
Baffle
Protection
Channel
Ceramic Blanket on Top
Baffle Boards & Blanket
even with front tube and
resting on back tube
Figure 23.2
