2
UP
UP
6. Mount push button. Use either screws or double
sided tape to mount push button.
•
Screw Mounting: To mount with screws, remove
back of case by pushing in tab on bottom with a
small screwdriver (see Figure 1). Note: Remove
material in screw holes (if needed) before mounting
with screws. Attach back of case to door jamb or
wall (see Figure 4). Snap front of push button on.
•
Tape Mounting: When attaching push button
using double sided tape, make sure the surface
of the door jamb or wall is clean.
7. Mount chime. Determine mounting location. The
base may be mounted horizontally or vertically
depending upon the specific model purchased.
• Use template on back cover of manual for screw
placement. Mark two hole locations 2-3/4" (7 cm)
apart. Note: Make sure holes are level before
drilling.
• Drill two 7/32" diameter pilot holes for wall an-
chors and insert anchors.
• Mount keyhole screws to wall leaving about 1/8"
(3 mm) of the screw threads exposed.
• Using keyholes on back of chime base, hang base
on screws (see Figure 5).
Figure 5
Figure 4
Keyhole Slots
(Horizontal Mounting)
Keyhole Slots
(Vertical Mounting)
Keyhole
Screw (x2)
Keyhole
Screw (x2)