3
598-1119-07
Channel settIngs
Note:
the channel is factory set. most instal-
lations will not require you to change the
two dip switches on your remote control or
receiver.
Note:
If purchasing more than one remote
control system, select different operating
channels unless you want one remote control
to operate multiple receivers.
These remote control products communicate by
using channels that can be changed by sliding
dip switches into the ON or OFF position on both
the transmitter and receiver unit(s).
Note:
Switch
settings must match. Other remote controlled
unit(s) may cause interference and the system
may not function properly. Follow the instructions
below for setting a new channel.
WarnIng: shock hazard. unplug receiver from
power source before changing channels.
1. Locate dip switches on both the transmitter
and receiver unit(s).
2. To change the channel, slide dip switches to ON
or OFF as needed. It is recommended to only
change one dip switch at a time and then check
to see if system is functioning properly.
IMPORTANT:
Dip switches must be in the
exact same configuration on both the trans-
mitter and receiver unit(s) for this system to
function properly.
Dip Switches - Shown in the
OFF (Down) Position
(Factory Default)
Dip Switches
ON
12 V
1 2
ON
12 V
1 2
Dip Switches
2-Button Remote Control with Back Removed
ON
1 2
Dip Switches
Indoor Plug-In Receiver
dIP sWItCh lOCatIOns
ON
1 2
Dip
Switches
Indoor/Outdoor Plug-In Receiver with Back
Jumper Cover Removed
