5
205072-02
Junction
Box
FINAL ASSEMBLY
1. Push the wires into the junction box. Make
sure none of the wires get pinched.
2. Slide the fixture assembly onto the mounting
screws. Tighten decorative nuts removed in step
1 of Installation section securely against fixture
base.
Mounting
Screw
Decorative Nut
3. Install one medium base light bulb (100 Watt
maximum). See Bulb Replacement section for
bulb installation.
4. Caulk around fixture base with silicone weather
sealant.
TESTING AND ADJUSTMENTS
1. Turn on the circuit breaker and light
switch.
Note:
Sensor has a 1
1
/
2
minute warm up period
before it will detect motion. When first turned
on wait 1
1
/
2
minutes.
2. Set:
• ON-TIME switch to TEST
• DualBrite® switch to OFF
• SENSITIVITY dial to Midway
3. Walk through the coverage area noting where
you are when the lights turn on. In TEST mode,
light will stay on for 5 seconds after sensing
motion and then turn off.
TEST 1 5 10
MINUTE
OFF
3
HOUR
6 DUSK
TO
DAWN
– +
SEN
