2
205072-02
GND
WIRING
CAUTION: DO NOT connect the RED
wire unless you want to control other
lights from the motion sensor (see Op-
tional Wiring).
Note:
All wiring must be run in accordance with
the National Electrical Code through conduit
or another acceptable means. Contact a quali-
fied electrician if there is any question as to the
suitability of the system.
One Motion Light
Two Motion Lights
Black
White
Green
or Bare
Light
Fixture
Black
White
Green
or Bare
Light
Fixture
Light
Fixture
Ground Screw
INSTALLATION
Bracket
Mounting
Screws
Junction
Box
Note:
We recommend having an assistant help
hold the decorative light during the wiring process.
For best performance, mount the fixture about 6
feet (1.8 m) above the ground.
1. Remove two decorative nuts.
2. Remove X-Bar.
3. Tighten mounting screws finger tight against
X-Bar.
4. Attach X-Bar to junction box.
X-Bar
Decorative Nut
Fixture Base
Fixture Mounting
Screw
X-Bar
WARNING: Turn power off at circuit
breaker or fuse. Place tape over circuit
breaker switch and verify power is off at
the fixture.
