ASSEMBLY INSTRUCTIONS
BATTING TEE (Cont.)
STEP 3 -
Screw the
STEM (Parts E-G)
onto
PART B
by twisting clockwise until tight, as
shown in
FIGURE 4
.
NOTE: The push pin should align with the back of the
BASE
when fully tight-
ened and allow you to adjust the height of the tee by selecting the
various hole positions on the
STEM.
FIGURE 4
STEP 4 -
Push
PART H (Tee Top)
onto
PART G (Top Stem)
until it stops
as shown in
FIGURE 5
.
NOTE: P
ART H (Tee Top)
is reversible and can fit either way.
FIGURE 5
PART H
STEP 5 -
You can now fill the BASE with sand or water to keep the
batting tee from tipping over.
After filling the
BASE
, push
STOPPER (Part D)
into the
fill hole until it snaps tight.
The HittingStation #1 Tee is now fully assembled.
95 West 650 South • St. George, UT 84770 • Toll Free: (800) 492-9334 • [email protected]
page 4
PARTS E-G
PART A
PART D
