WARNING! WARNING! WARNING!
USE REAL BASEBALLS IN THIS MACHINE AT YOUR OWN RISK!
IT IS RECOMMENDED THAT YOU ONLY USE DIMPLED PITCHING MACHINE BASEBALLS TO PITCH
TO BATTERS. PITCHING MACHINES THAT USE A WHEEL TO THROW BASEBALLS WILL THROW REAL
BASEBALLS INACCURATELY BECAUSE OF THE SEAMS ON THE BALL AND MAY HIT A BATTER AND
CAUSE PHYSICAL INJURY!
IMPORTANT: THIS PRODUCT IS TO BE USED BY ADULTS ONLY. MAKE SURE MACHINE IS
TURNED OFF BEFORE ASSEMBLY! KEEP HANDS AND ALL BODY PARTS AWAY FROM BALL EXIT!
SERIOUS HAND AND BODILY INJURY MAY RESULT IF USED INCORRECTLY!
Step 1: Make sure every person and everything is clear of pitching machine ball path.
Step 2: Turn pitching machine variable speed control knob off (counter-clockwise until you hear a click).
Step 3: Bolt housing clamp to leg support tube(s) by inserting clamp bolt(2X) through clamp
hole(2X) & leg support clamp hole(2X).
Step 4: Slide flat washer(2X) & lock washer(2X) over bolt(2X) and tighten clamp knob(2X).
Step 5: Slide galvanized steel legs into leg support tubes and tighten thumb screws.
Step 6: Plug A/C power cord into 3 prong power outlet.
Step 7: Aim pitching machine at desired target.
Step 8: Turn variable speed control knob on (clockwise to approximately #3 on speed control).
Step 9: Pitch a ball & rotate speed control knob to desired estimated speed.
Step 10: Adjust pitch height by loosening the pitch height adjustment knob and rotating
the housing to desired location. Re-tighten pitch height adjustment knob.
Step 11: Make sure machine is pitching at desired target before allowing batter to start batting.
95 West 650 South • St. George, Utah 84770 • PH: 800-492-9334 • PH: 435-656-1756 • Fax: 435-688-0741
Auto-Ball Feeder Brackets
Leg Support Tube(s)
Pitch Height
Adjustment Knob
(Clamp Knob, lock
washer & flat washer)
Carrying Handle
Variable Speed Control Knob
Auto-Ball Feeder Plug
A/C Power Cord
Housing
Housing Clamp
Flat washer, lock washer,
clamp knob
Clamp Bolt(2X)
®
Pitching Machine Instructions
(continued)