29
HEAT & GLO • PHOENIX42-IFT Installation Manual • 4096-901 Rev. A
• 02/18
• Insert the male slip section into the female slip sec-
tion installed in step 2. See Figure 7.13.
Male Slip Section
Figure 7.13
• Slide slip section pieces together until mounting plate
is tight to wall shield and secure with (8) screws. See
Figure 7.14.
Secure with
(8) screws
Figure 7.14
•
Position the cap base on exterior wall, level, and
secure with (4) screws provided. When properly in
-
stalled, the damper collar must extend into the wall
shield a minimum of 1-1/2 inches.. See Figure 7.16.
Cap
Base
Damper
Collar
Figure 7.16
•
Remove louvered cover from motor assembly, (8)
screws. See Figure 7.17.
Louvered
Cover
Motor
Assembly
Figure 7.17
Note
: Damper blade should move freely and be
clear of any obstructions.
•
Remove motor assembly from cap base (8) screws.
See Figure 7.15.
Figure 7.15
